For instance, you can’t use a RainBird sprinkler head in a Toro system. One common mistake, Jeff warns, is an incorrect sprinkler head. According to Jeff Watson of Bright Water Irrigation and Lighting in Central Florida, if homeowners get the wrong one, the spray in that zone will be distributed unevenly. Before you buy a new sprinkler head, make sure you have the right one. The most common sprinkler head problem is damage. It takes just a few minutes to clear the debris. Turn the system on to check the spray direction is correct. Check the direction of the spray head, then release the vise grip.Once clear, put the filter back in and screw the cap on.Flush the line for a few seconds before reassembling the head.Unscrew the tip and lift out the filter.Lift the sprinkler head part that houses the filter and clamp with a vise grip.If your sprinkler head doesn’t show signs of damage, simply clearing the debris it has collected over time may do the trick. How to Clear Debris and Adjust Spray Nozzles Rotary sprinklers may go full circle, so adjust the degree to which they turn. Adjust the spray distance on each of the heads, considering sidewalks and driveways.Turn the sprinklers on to be sure that they are all working.Adjust the speed of the water output by pushing the tabs on the nozzle.To decrease the width of the spray pattern, turn the screw clockwise.To increase the width of the spray pattern, turn the screw counterclockwise.Use a flat-head screwdriver to rotate the adjustment screw on the top of the nozzle. You must adjust the pop-up sprinkler heads while the sprinkler is running.Instructions on these vary with different manufacturers, so you’ll need to check your manufacturer’s specific instructions to make adjustments.Rotor sprinkler heads are held in place with a setscrew.You may need to adjust both the radius and the spray arc.Turn the screw clockwise to lower the water pressure on the spray head if too much water is shooting out.You may need to adjust the water spray in the direction of your lawn.Find the spray radius adjustment screw at the top of the nozzle. You’ll need a flat-head screwdriver and possibly a few other tools to adjust the heads. The most common types are stationary, rotor, pop-up, and pulsating sprinkler heads. There are many types of sprinkler heads and each one has different patterns or uses. Also look for areas where its spray pattern isn’t functioning properly, watering unequally, or not at all. Observe how the water is distributed and the amount of water. Turn the system on to conduct a sprinkler head audit. If it’s been a while since you’ve done anything with your sprinkler system (aside from programming), you may not even know where all of your sprinkler heads are. How to Adjust Sprinkler Heads’ Spray Pattern Photo Credit: Daniel R.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |